MSP430FR4133IG48R Встроенные - Микроконтроллеры от Texas Instruments

Description MSP430FR41xx ultra-low-power (ULP) microcontroller family supports low-cost LCD applications that benefit from an integrated 10-bit ADC such as remote controls, thermostats, smart meters, blood glucose monitors, and blood pressure monitors.
The MCUs feature a powerful 16-bit RISC CPU, 16-bit registers, and constant generators that contribute to maximum code efficiency.
The digitally controlled oscillator (DCO) allows the device to wake up from low-power modes to active mode in less than 10 µs.
The architecture, combined with extensive low-power modes, is optimized to achieve extended battery life in portable measurement applications.
The MSP430™ FRAM microcontroller platform combines uniquely embedded ferroelectric random access memory (FRAM) and a holistic ultra-low-power system architecture, allowing system designers to increase performance while lowering energy consumption. FRAM technology combines the low-energy fast writes, flexibility, and endurance of RAM with the nonvolatile behavior of flash. MSP430FR41x MCUs are supported by an extensive hardware and software ecosystem with reference designs and code examples to get your design started quickly. Development kits for the MSP430FR41xx include the MSP-EXP430FR4133 LaunchPad™ development kit and the MSP-TS430PM64D 64-pin target development board. TI also provides free MSP430Ware™ software, which is available as a component of Code Composer Studio™ IDE desktop and cloud versions within TI Resource Explorer. MSP430 MCUs are also supported by extensive online collateral, such as our housekeeping example series, MSP Academy training, and online support through the TI E2E™ support forums.   
Features
• Embedded microcontroller– 16-bit RISC architecture up to 16 MHz– Wide supply voltage range from 3.6 V down to 1.8 V
• Optimized low-power modes (at 3 V)– Active mode: 126 µA/MHz– Standby mode: <1 µA with real-time clock (RTC) counter and liquid crystal display (LCD)– Shutdown (LPM4.5): 15 nA
• High-performance analog– 10-channel 10-bit analog-to-digital converter (ADC)
• Internal 1.5-V reference
• Sample-and-hold 200 ksps– Low-power LCD driver
• Supports up to 4×36- or 8×32-segment LCD configuration
• On-chip charge pump to keep LCD active in standby mode (LPM3.5)
• Each LCD pin software configurable as SEG or COM
• Contrast control from 2.6 V to 3.5 V by 0.06‑V steps
• Low-power ferroelectric RAM (FRAM)– Up to 15.5KB of nonvolatile memory– Built-in error correction code (ECC)– Configurable write protection– Unified memory of program, constants, and storage– 1015 write cycle endurance– Radiation resistant and nonmagnetic
• Intelligent digital peripherals– IR modulation logic– Two 16-bit timers with three capture/compare registers each (Timer_A3)– One 16-bit counter-only RTC counter– 16-bit cyclic redundancy checker (CRC)
• Enhanced serial communications– Enhanced USCI A (eUSCI_A) supports UART, IrDA, and SPI– Enhanced USCI B (eUSCI_B) supports SPI and I2C   Applications
• Remote controls
•
Thermostats
• Water meters
• Heat meters
• Gas meters
• One-time password tokens
• Blood glucose monitors
• Blood pressure monitors