PUMH16 Resistor Equipped Transistors (RETs) от Nexperia

Specifies the electrical channel configuration, such as unidirectional or bidirectional, for signal or power routing. This attribute is critical for selecting components like multiplexers, isolators, or level shifters. Verify the channel type against your application requirements and the datasheet to ensure correct signal flow and compatibility.

Identifies the company that designed and produced the component. Buyers often filter by manufacturer to ensure brand reliability, quality standards, and supply chain consistency. Verify the manufacturer against the datasheet and official packaging to avoid counterfeit parts.

Identifies the physical package type or designator, such as SOIC, QFN, or DIP. This determines PCB footprint, thermal performance, and assembly compatibility. Verify the package matches your board layout and manufacturing capabilities. Check the datasheet for exact dimensions.

Collector-emitter voltage with the base open. This is the maximum voltage that can be applied between collector and emitter without causing breakdown. Ensure your supply voltage and transients stay below this rating to prevent transistor failure.

Maximum continuous collector current for a bipolar transistor. This is the highest current the transistor can handle without exceeding its thermal or reliability limits. Verify that your application's peak current stays below this rating to avoid overheating or damage.

Total power dissipation capability of the device, representing the maximum power it can handle continuously. This is essential for thermal management in your design. Verify that your circuit's power losses do not exceed this limit to avoid overheating and ensure long-term reliability.

Physical dimensions of the component in millimeters. Essential for PCB layout and mechanical fit. Buyers and engineers compare size to ensure the part fits the design envelope. Always check the datasheet for exact dimensions and tolerances.

Maximum junction temperature is the highest allowable operating temperature of the semiconductor die. Exceeding it can cause thermal damage or reduced reliability. Compare this limit with your application's worst-case thermal conditions and verify against the datasheet's thermal specifications.

Indicates the component meets AEC-Q or other automotive reliability standards. Verify the specific qualification level in the datasheet. Essential for designs targeting automotive applications where extended temperature ranges and high vibration resistance are critical.

Typical resistance of the first internal resistor in a transistor or resistor network. This value helps determine biasing and input impedance. Check the datasheet for tolerance and temperature coefficient to ensure stable operation across your operating range.

Typical resistance of the second internal resistor in a transistor or resistor network. This value affects voltage divider ratios and switching thresholds. Verify the datasheet for tolerance and temperature drift to ensure consistent performance in your circuit.