DRV8830DGQ Драйверы и контроллеры двигателей PMIC от Texas Instruments

Обзор продукта

Обзор

Description The DRV841x2 are high-performance, integrated dual full-bridge motor driver with an advanced protection system. Because of the low RDS(on) of the H-Bridge MOSFETs and intelligent gate drive design, the efficiency of these motor drivers can be up to 97%. This high efficiency enables the use of smaller power supplies and heatsinks, and the devices are good candidates for energy-efficient applications. The DRV841x2 requires two power supplies, one at 12 V for GVDD and VDD, and another up to 50 V for PVDD. The DRV841x2 can operate at up to 500-kHz switching frequency while still maintaining precise control and high efficiency. The devices also have an innovative protection system safeguarding the device against a wide range of fault conditions that could damage the system. These safeguards are shortcircuit protection, overcurrent protection, undervoltage protection, and two-stage thermal protection. The DRV841x2 has a current-limiting circuit that prevents device shutdown during load transients such as motor start-up. A programmable overcurrent detector allows adjustable current limit and protection level to meet different motor requirements. The DRV841x2 has unique independent supply and ground pins for each half-bridge. These pins make it possible to provide current measurement through external shunt resistor and support multiple motors with different power supply voltage requirements. Features • High-Efficiency Power Stage (up to 97%) With Low RDS(on) MOSFETs (110 mΩ at TJ = 25°C) • Operating Supply Voltage up to 52 V • DRV8412 (Power Pad Down): up to 2 × 3-A Continuous Output Current (2 × 6-A Peak) in Dual Full-Bridge Mode or 6-A Continuous Current in Parallel Mode (12-A Peak) • DRV8432 (Power Pad Up): up to 2 × 7-A Continuous Output Current (2 × 12-A Peak) in Dual Full-Bridge Mode or 14-A Continuous Current in Parallel Mode (24-A Peak) • PWM Operating Frequency up to 500 kHz • Integrated Self-Protection Circuits Including Undervoltage, Overtemperature, Overload, and Short Circuit • Programmable Cycle-by-Cycle Current Limit Protection • Independent Supply and Ground Pins for Each Half Bridge • Intelligent Gate Drive and Cross Conduction Prevention • No External Snubber or Schottky Diode is Required Applications • Brushed DC and Stepper Motors • Three-Phase Permanent Magnet Synchronous Motors • Robotic and Haptic Control System • Actuators and Pumps • Precision Instruments • TEC Drivers • LED Lighting Drivers