MT65B18G16120A00QH-92:A High Bandwidth Memory от Micron Technology

Specifies the number of components supplied on a single tape and reel. This is important for production planning and inventory management. Verify the exact quantity against the datasheet or packaging label before ordering to ensure it matches your assembly requirements.

Select the category that best describes the component, such as IC, resistor, capacitor, or connector. This classification helps filter parts by function and technology. Verify the part type against the datasheet to ensure it matches your application requirements.

Indicates how many individual components are integrated within a single package. Useful for estimating board space and assembly complexity. Check the datasheet to understand the exact composition and any internal connections that may affect your design.

Specifies the maximum clock frequency the device can reliably operate at. Compare this value with your system timing requirements to ensure proper synchronization and data throughput. Always verify against the datasheet for exact conditions and tolerances.

Specifies the voltage level for input and output pins of the component. Check this against your system's logic levels to ensure compatibility. Verify the absolute maximum ratings in the datasheet to avoid damage.

Indicates the current lifecycle stage of the electronic component, such as active, obsolete, or end-of-life. Buyers should verify this code against the manufacturer datasheet to ensure long-term availability and avoid design risks.

Manufacturing technology or process used for the component, such as thin film, thick film, or semiconductor process. Affects performance, stability, and cost. Confirm the technology matches your application requirements and environmental conditions.

Indicates how many individual components are packed into a given area on a board or module. Higher density often means more functionality in less space, but may affect thermal management and repairability. Compare this value when evaluating miniaturization and manufacturing complexity.

Specifies the ambient temperature range within which the component reliably functions. Compare this with your application's thermal environment to ensure proper operation. Always verify against the datasheet for derating curves and maximum ratings.

Physical dimensions of the component package, typically length, width, and height. These measurements determine PCB footprint and mechanical fit. Verify against the datasheet for accurate board layout and assembly clearance.

Select the physical package style of the component, such as SMD, through-hole, or BGA. This affects board layout, thermal performance, and assembly methods. Verify the exact package code against the datasheet to ensure compatibility with your PCB design and manufacturing process.

Specifies the maximum clock frequency or data rate of the component. This is critical for timing and performance. Verify the speed grade in the datasheet to ensure it meets your system's throughput requirements and that signal integrity is maintained at that speed.

Describes the internal arrangement of components within a multi-element device, such as series, parallel, or common pin configurations. Essential for circuit design and pinout planning. Always refer to the datasheet for the exact schematic and electrical characteristics.