Поставка оригинальных DS2450S, Сбор данных - Аналого-цифровые преобразователи (АЦП), от Maxim Integrated

The DS2450 1-Wire Quad A/D Converter is based on a successive-approximation analog to digital converter with a four to one analog multiplexer. Each input channel has its own register set to store the input voltage range, resolution, and alarm threshold values as well as flags to enable participation of the device in the conditional search if the input voltage leaves the specified range. Two alarm flags for each channel indicate if the voltage measured was too high or too low without requiring the bus master to do the comparison. Each A/D conversion is initiated by the bus master. A channel not used as analog input can serve as a digital open-drain output. After disabling the input the bus master can directly switch on or off the open-drain transistor at the selected channel.
FEATURES
• Four high-impedance inputs to measure analog voltages over the 1-Wire bus
• User programmable input range (2.56V, 5.12V), resolution (1 to 16 bits) and alarm thresholds
• 5V, single supply operation
• Very low power: 2.5 mW active, 25 mW idle
• Built-in multidrop controller allows multiple DS2450’s to be identified and operated on a common 1-Wire bus
• Responds to Conditional Search if the analog voltage crosses the alarm thresholds
• Channels not used as analog input can serve as open drain digital outputs for closed-loop control
• Directly connects to a single port pin of a microprocessor and communicates at up to 16.3k bits per second
• Overdrive mode boosts communication speed to 142k bits per second
• On-chip 16-bit CRC-generator for safeguarding data transfers
• Unique, factory-lasered and tested 64-bit registration number (8-bit family code + 48-bit serial number 8-bit CRC tester) assures absolute traceability because no two parts are alike
• 8-bit family code specifies device communication requirements to bus master
• Operating temperature range from -40°C to +85°C
• Compact, low cost 8-pin SOIC surface mount package