AS5048A-TS_EK_AB Magnetic Sensors / Hall-Effect Switches от ams

Describes the primary purpose or role of the board in an electronic system, such as power conversion, signal conditioning, or motor control. Helps engineers quickly identify if the board matches their application requirements before reviewing detailed specifications.

Identifies the specific integrated circuit (IC) used on the board. This is critical for understanding the board's capabilities, compatibility, and potential for customization. Check the IC datasheet for detailed electrical characteristics and application notes.

Maximum distance at which the sensor reliably detects an object. Compare this range with your application's required detection distance. Always verify against the datasheet, as actual performance may vary with target material and environmental conditions.

Specifies the underlying sensing technology, such as optical, inductive, or capacitive. This determines the sensor's operating principle and application suitability. Verify the exact type against the datasheet to ensure compatibility with your target environment and measurement requirements.

Identifies the company that designed and produced the component. Buyers often filter by manufacturer to ensure brand reliability, quality standards, and supply chain consistency. Verify the manufacturer against the datasheet and official packaging to avoid counterfeit parts.

Specifies the communication protocol or interface type used by the component, such as I2C, SPI, UART, or USB. This determines how the device connects to a microcontroller or system. Verify compatibility with your host controller and bus voltage levels before design-in.

Specifies the nominal operating voltage that must be applied to the component for proper function. Verify this value against your system's power rail and the datasheet's absolute maximum ratings to ensure reliable operation and avoid damage.

Resolution defines the smallest detectable change in a sensor's output or measurement. For electronic components, it determines precision and accuracy. Engineers compare resolution to ensure the component meets system requirements. Always verify the datasheet for exact resolution specifications under operating conditions.

Current stage in the product's lifecycle, such as Active, Obsolete, or End of Life. This indicates availability and long-term supply risk. Check this before designing in a part to ensure it will be available for your product's production lifetime.

Select the category that best describes this electronic component, such as capacitor, resistor, diode, or connector. This classification helps you filter and compare similar parts. Verify the exact type against the datasheet to ensure it matches your application requirements.

Manufacturer-assigned identifier for the component. Use it to locate datasheets, verify specifications, and ensure compatibility with your design. Always cross-check the part number against the manufacturer's official documentation to avoid counterfeit or obsolete parts.